Lenox also extends into Adams County.
About Lenox Fire and EMS Frequencies
Quick answer: County-level fire dispatch that covers Lenox: Taylor County Fire 154.2050 MHz, narrow FM, 136.5 PL.
- 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
Data updated .
Taylor County channels that also cover Lenox
Fire Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Taylor County Fire | Taylor County Fire – Dispatch | 154.2050 In 150.7900 | 136.5 PL | FMN | WPCC623 |
Nearest trunked radio sites
Distances are measured from the center of Lenox.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does the fire department use in Lenox?
We do not have a fire dispatch channel listed specifically for Lenox. The county-level fire dispatch channels in the same county: Taylor County Fire 154.2050 MHz, narrow FM, 136.5 PL.
What scanner do I need to listen to fire and EMS in Lenox?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in Lenox?
For Lenox, start with the Corning site of Iowa Statewide Interoperable Communications System (ISICS). Its control channels are 773.80625, 774.05625, 774.30625 MHz. Program a control channel first; the scanner finds the voice channels from it.