ODonnell also extends into Dawson County.
About ODonnell Fire and EMS Frequencies
Quick answer: County-level fire dispatch that covers ODonnell: Lynn County Fire 155.1975 MHz, FM, no tone.
- 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
Data updated .
Lynn County channels that also cover ODonnell
Fire Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Lynn County Fire | Lynn Co. Fire/EMS Primary | 155.1975 In 154.0025 | FM | WQDH848 |
Nearest trunked radio sites
Distances are measured from the center of ODonnell.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does the fire department use in ODonnell?
We do not have a fire dispatch channel listed specifically for ODonnell. The county-level fire dispatch channels in the same county: Lynn County Fire 155.1975 MHz, FM, no tone.
What scanner do I need to listen to fire and EMS in ODonnell?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in ODonnell?
For ODonnell, start with the Ransom Canyon site of Lubbock City-County Mutual Radio System. Its control channels are 856.2375, 857.2375, 858.2375 MHz. Program a control channel first; the scanner finds the voice channels from it.