Skip to content

Mitchell Fire and EMS Frequencies

We do not have frequencies listed specifically for Mitchell in Scotts Bluff County, Nebraska yet. Countywide channels for Scotts Bluff County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Mitchell 800 (Nebraska State Radio System), about 7 miles away.

About Mitchell Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Mitchell: Rural Fire Paging 155.1300 MHz, narrow FM, no tone; Scotts Bluff County Fire 152.4800 MHz, narrow FM, no tone. County-level ems dispatch that covers Mitchell: Scotts Bluff County EMS 461.9000 MHz, narrow FM, 110.9 PL.

  • 10 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • 3 conventional channels use a digital mode (P25, DMR), which needs a scanner that decodes those modes.
  • Trunked radio systems that carry fire and EMS traffic here: Nebraska State Radio System: 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Mitchell, start with the Mitchell 800 site of Nebraska State Radio System, about 7 miles away. Its control channels: 859.4375, 859.7125, 859.9875 MHz.
  • 1 listed entry is marked encrypted. No scanner can decode encrypted audio.

Data updated .

Scotts Bluff County channels that also cover Mitchell

Fire Dispatch

Fire Dispatch frequencies for Scotts Bluff County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Rural Fire PagingRural Fire Paging155.1300FMNWQZU822
Scotts Bluff County FireFire Paging152.4800FMNWNSG365
Scotts Bluff County FireScotts Bluff County Fire – VHF154.4450
In 153.8900
CSQFMNWNFU718
Scotts Bluff County FireScotts Bluff County Fire – Dispatch (remote RF link)452.1000141.3 PLFMNKAI875
Scotts Bluff County FireScottsbluff Rural/Mitchell/Minetatre Fire Department's453.3750
In 458.3750
FMNWQCL679
Scotts Bluff County FireScotts Bluff County Fire – 800860.4875
In 815.4875
NAC 156P25WPKU672

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Scotts Bluff County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Scotts Bluff County FireFire Talkaround854.9875
In 809.9875
FMNWPWM264

EMS Dispatch

EMS Dispatch frequencies for Scotts Bluff County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Scotts Bluff County EMSDispatch.9461.9000110.9 PLFMN—
Scotts Bluff County EMSDispatch.8461.9000114.8 PLFMN—
Scotts Bluff County EMSDispatch.9461.900071.9 PLFMN—
Scotts Bluff County EMSScotts Bluff County EMS – Dispatch462.9750
In 467.9750
114.8 PLFMNWPIS314

EMS Tactical

EMS Tactical frequencies for Scotts Bluff County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Scotts Bluff County EMSScotts Bluff County EMS – Tactical Channel460.5500
In 465.5500
CC 4 · TG 1 · SL 1DMRWQSX464
Scotts Bluff County EMSScotts Bluff County EMS – Tactical Channel463.1875
In 468.1875
CC 3 · TG 1 · SL 1DMRWQAS946

Nebraska State Radio System

1 encrypted talkgroup (cannot be monitored)
Nebraska State Radio System encrypted talkgroups
AgencyDescriptionTalkgroupHexMode
Scotts Bluff County FireScotts Bluff County Fire – Dispatch52117cb95T Encrypted

Nearest trunked radio sites

Distances are measured from the center of Mitchell.

Mitchell 800 · Nebraska State Radio System
RFSS 1 · Site 23 (hex 17) · NAC B80 · about 7 mi away
Control 859.4375, 859.7125, 859.9875
Voice 859.2125
Mitchell · Nebraska State Radio System
RFSS 1 · Site 35 (hex 23) · NAC B82 · about 7 mi away
Control 155.19, 155.6925
Voice 154.2875, 154.695
Scottsbluff · Nebraska State Radio System
RFSS 1 · Site 20 (hex 14) · NAC B80 · about 9 mi away
Control 856.4875, 856.7625, 857.0375
Voice 856.2625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Mitchell?

We do not have a fire dispatch channel listed specifically for Mitchell. The county-level fire dispatch channels in the same county: Rural Fire Paging 155.1300 MHz, narrow FM, no tone; Scotts Bluff County Fire 152.4800 MHz, narrow FM, no tone.

What frequency does EMS or the ambulance service use in Mitchell?

We do not have a EMS dispatch channel listed specifically for Mitchell. The county-level EMS dispatch channels in the same county: Scotts Bluff County EMS 461.9000 MHz, narrow FM, 110.9 PL.

Do fire departments and EMS use a trunked radio system in Mitchell?

Yes. The county-level systems that cover Mitchell are Fire and EMS talkgroups are listed for Nebraska State Radio System: 1 talkgroup. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Mitchell?

The analog conventional channels can be heard on any scanner; a scanner that decodes P25, DMR is needed for the digital conventional channels; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Mitchell?

For Mitchell, start with the Mitchell 800 site of Nebraska State Radio System. Its control channels are 859.4375, 859.7125, 859.9875 MHz. Program a control channel first; the scanner finds the voice channels from it.