About Wilcox Fire and EMS Frequencies
Quick answer: Fire dispatch for Wilcox: Wilcox Fire 453.8500 MHz, narrow FM, 432 DPL.
- 4 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
Data updated .
Wilcox conventional frequencies
Fire Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Wilcox Fire | Wilcox Fire – Dispatch | 453.8500 In 458.8500 | 432 DPL | FMN | WPMV899 |
| Wilcox Fire | Wilcox Fire – Dispatch | 453.8500 In 458.8500 | 432 DPL | FMN | WPMV899 |
Fire Ground / Tactical
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Wilcox Fire | Wilcox Fire – Fire Ground | 453.5750 In 458.5750 | 532 DPL | FMN | WPMV899 |
Kearney County channels that also cover Wilcox
Fire Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Kearney County Fire | Kearney County Fire – Dispatch | 453.1250 In 458.1250 | 263 DPL | FMN | WQTY644 |
Nearest trunked radio sites
Distances are measured from the center of Wilcox.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does the fire department use in Wilcox?
Fire dispatch channels listed for Wilcox: Wilcox Fire 453.8500 MHz, narrow FM, 432 DPL.
What scanner do I need to listen to fire and EMS in Wilcox?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in Wilcox?
For Wilcox, start with the Holdrege site of Nebraska State Radio System. Its control channels are 155.505, 156.1275 MHz. Program a control channel first; the scanner finds the voice channels from it.
Are Wilcox fire and EMS frequencies encrypted?
None of the 3 conventional frequencies listed for Wilcox are marked encrypted.