Skip to content

Randall Fire and EMS Frequencies

We do not have frequencies listed specifically for Randall in Hamilton County, Iowa yet. Countywide channels for Hamilton County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Mackey (Iowa Statewide Interoperable Communications System (ISICS)), about 11 miles away.

About Randall Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Randall: Hamilton County Fire 154.2350 MHz, narrow FM, no tone. County-level ems dispatch that covers Randall: Hamilton County Hospital 155.3400 MHz, FM, CSQ. Trunked: Iowa Statewide Interoperable Communications System (ISICS), for example Hamilton County Fire talkgroup 31008 (hex 7920).

  • 3 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Iowa Statewide Interoperable Communications System (ISICS): 8 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Randall, start with the Mackey site of Iowa Statewide Interoperable Communications System (ISICS), about 11 miles away. Its control channels: 770.71875, 770.96875, 774.59375 MHz.

Data updated .

Hamilton County channels that also cover Randall

Fire Dispatch

Fire Dispatch frequencies for Hamilton County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Hamilton County FireHamilton County Fire – Dispatch154.2350
In 159.0450
FMNWQGS402

EMS Dispatch

EMS Dispatch frequencies for Hamilton County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Hamilton County HospitalHamilton County Hospital – Dispatch (167.9PL on Base side)155.3400CSQFMKQS751

Hospitals & Medical

Hospitals & Medical frequencies for Hamilton County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Hamilton County HospitalHamilton County Hospital – Paging155.8650CSQFMWSL644

Iowa Statewide Interoperable Communications System (ISICS)

Iowa Statewide Interoperable Communications System (ISICS) talkgroups
AgencyDescriptionTalkgroupHexMode
Hamilton County FireHamilton County Fire – Dispatch310087920T
Hamilton County FireFire/EMS Roam310177929T
Hamilton County FireJewell Fire Page31034793aT
Hamilton County FireDispatch VHF Patch310457945T
Hamilton Webster City FireHamilton Webster City Fire – Dispatch310407940T
Hamilton County FireCounty Fire31006791eT
Hamilton County EMSEMS Operations31018792aT
Hamilton County EMSVan Diest EMS Dispatch310427942T

Nearest trunked radio sites

Distances are measured from the center of Randall.

Mackey · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 2 · Site 108 (hex 6C) · NAC 4C0 · about 11 mi away
Control 770.71875, 770.96875, 774.59375, 774.84375
Hamilton Co Simulcast · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 2 · Site 40 (hex 28) · NAC 4C0 · about 12 mi away
Control 774.79375
Voice 770.66875, 770.91875, 774.54375
Site-1 · Iowa State University
Site 1 (hex 1) · about 16 mi away
Control 859.5625, 860.5625
Voice 856.5625, 857.5625, 858.5625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Randall?

We do not have a fire dispatch channel listed specifically for Randall. The county-level fire dispatch channels in the same county: Hamilton County Fire 154.2350 MHz, narrow FM, no tone.

What frequency does EMS or the ambulance service use in Randall?

We do not have a EMS dispatch channel listed specifically for Randall. The county-level EMS dispatch channels in the same county: Hamilton County Hospital 155.3400 MHz, FM, CSQ.

Do fire departments and EMS use a trunked radio system in Randall?

Yes. The county-level systems that cover Randall are Fire and EMS talkgroups are listed for Iowa Statewide Interoperable Communications System (ISICS): 8 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Randall?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Randall?

For Randall, start with the Mackey site of Iowa Statewide Interoperable Communications System (ISICS). Its control channels are 770.71875, 770.96875, 774.59375, 774.84375 MHz. Program a control channel first; the scanner finds the voice channels from it.