Skip to content

Stuart Fire and EMS Frequencies

We do not have frequencies listed specifically for Stuart in Guthrie County, Iowa yet. Countywide channels for Guthrie County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Greenfield (Iowa Statewide Interoperable Communications System (ISICS)), about 15 miles away.

Stuart also extends into Adair County.

About Stuart Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Stuart: Guthrie County Fire 154.2350 MHz, narrow FM, 146.2 PL. Trunked: Iowa Statewide Interoperable Communications System (ISICS), for example Guthrie County Fire talkgroup 30820 (hex 7864).

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Iowa Statewide Interoperable Communications System (ISICS): 5 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Stuart, start with the Greenfield site of Iowa Statewide Interoperable Communications System (ISICS), about 15 miles away. Its control channels: 770.96875, 774.59375, 774.84375 MHz.

Data updated .

Guthrie County channels that also cover Stuart

Fire Dispatch

Fire Dispatch frequencies for Guthrie County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Guthrie County FireGuthrie County Fire – Dispatch154.2350146.2 PLFMNWQCX704

Iowa Statewide Interoperable Communications System (ISICS)

Iowa Statewide Interoperable Communications System (ISICS) talkgroups
AgencyDescriptionTalkgroupHexMode
Guthrie County FireGuthrie County Fire – Dispatch308207864T
Guthrie County FireGuthrie County Fire – Dispatch3089278acT
Guthrie County FireGuthrie County Fire – Tactical Channel308217865T
Guthrie County FireGuthrie County Fire – Tactical Channel308227866T
Guthrie County EMSGuthrie County EMA308187862T

Nearest trunked radio sites

Distances are measured from the center of Stuart.

Greenfield · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 2 · Site 1 (hex 1) · about 15 mi away
Control 770.96875, 774.59375, 774.84375
Adair · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 1 · Site 6 (hex 6) · NAC 4C0 · about 17 mi away
Control 770.21875, 770.46875
Voice 769.21875, 769.46875, 769.71875, 769.96875
Winterset · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 1 · Site 61 (hex 3D) · NAC 4C0 · about 18 mi away
Control 773.04375, 773.54375, 774.04375
Voice 770.95625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Stuart?

We do not have a fire dispatch channel listed specifically for Stuart. The county-level fire dispatch channels in the same county: Guthrie County Fire 154.2350 MHz, narrow FM, 146.2 PL.

Do fire departments and EMS use a trunked radio system in Stuart?

Yes. The county-level systems that cover Stuart are Fire and EMS talkgroups are listed for Iowa Statewide Interoperable Communications System (ISICS): 5 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Stuart?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Stuart?

For Stuart, start with the Greenfield site of Iowa Statewide Interoperable Communications System (ISICS). Its control channels are 770.96875, 774.59375, 774.84375 MHz. Program a control channel first; the scanner finds the voice channels from it.