Skip to content

Hatch Fire and EMS Frequencies

We do not have frequencies listed specifically for Hatch in Garfield County, Utah yet. Countywide channels for Garfield County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Wilson Peak (Utah Communications Authority (P25)), about 8 miles away.

About Hatch Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Hatch: Garfield County Fire 155.8800 MHz, narrow FM, 146.2 PL. Trunked: Utah Communications Authority (P25) (Project 25), for example Garfield County Fire talkgroup 7203 (hex 1c23).

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Utah Communications Authority (P25) (Project 25): 8 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Hatch, start with the Wilson Peak site of Utah Communications Authority (P25), about 8 miles away. Its control channels: 769.90625, 774.03125 MHz.

Data updated .

Garfield County channels that also cover Hatch

Fire Dispatch

Fire Dispatch frequencies for Garfield County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Garfield County FireGarfield County Fire – Dispatch (Dutton)155.8800
In 158.9400
146.2 PLFMNKNCR274

Utah Communications Authority (P25)

Project 25 · System ID 00A

Utah Communications Authority (P25) talkgroups
AgencyDescriptionTalkgroupHexMode
Garfield County FireGarfield County Fire – Dispatch72031c23T
Garfield County FireFire Operations72071c27T
Garfield County FireGarfield County Fire – Alternate72041c24T
Garfield County FireSearch and Rescue72061c26T
Garfield County FireSearch and Rescue Car to Car72141c2eT
Garfield County FireCar to Car72151c2fT
Garfield County EMSGarfield County EMS – Alternate72051c25T
Garfield County EMSCar to Car72161c30T

Nearest trunked radio sites

Distances are measured from the center of Hatch.

Wilson Peak · Utah Communications Authority (P25)
Project 25 · RFSS 119 · Site 119 (hex 77) · NAC 207 · about 8 mi away
Control 769.90625, 774.03125
Voice 772.43125, 772.64375, 772.93125, 773.13125
Spencers Bench · Utah Communications Authority (P25)
Project 25 · RFSS 101 · Site 101 (hex 65) · NAC 1F5 · about 20 mi away
Control 771.41875, 774.55625
Voice 771.66875, 772.04375, 772.25625, 772.50625, 773.81875
Tropic · Utah Communications Authority (P25)
Project 25 · RFSS 135 · Site 135 (hex 87) · NAC 217 · about 20 mi away
Control 769.28125, 772.35625
Voice 770.36875, 771.29375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Hatch?

We do not have a fire dispatch channel listed specifically for Hatch. The county-level fire dispatch channels in the same county: Garfield County Fire 155.8800 MHz, narrow FM, 146.2 PL.

Do fire departments and EMS use a trunked radio system in Hatch?

Yes. The county-level systems that cover Hatch are Fire and EMS talkgroups are listed for Utah Communications Authority (P25) (Project 25): 8 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Hatch?

The analog conventional channels can be heard on any scanner; a trunking scanner that supports Project 25 is needed for the trunked talkgroups.

What are the control channels for trunked radio in Hatch?

For Hatch, start with the Wilson Peak site of Utah Communications Authority (P25). Its control channels are 769.90625, 774.03125 MHz. Program a control channel first; the scanner finds the voice channels from it.