Skip to content

Riverside Fire and EMS Frequencies

We do not have frequencies listed specifically for Riverside in Box Elder County, Utah yet. Countywide channels for Box Elder County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Newton Hill (Utah Communications Authority (P25)), about 11 miles away.

About Riverside Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Riverside: Box Elder County Fire 154.3550 MHz, narrow FM, no tone. Trunked: Utah Communications Authority (P25) (Project 25), for example Box Elder County Fire talkgroup 4728 (hex 1278).

  • 3 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Utah Communications Authority (P25) (Project 25): 8 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Riverside, start with the Newton Hill site of Utah Communications Authority (P25), about 11 miles away. Its control channels: 769.09375, 774.71875 MHz.

Data updated .

Box Elder County channels that also cover Riverside

Fire Dispatch

Fire Dispatch frequencies for Box Elder County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Box Elder County FireFire/EMS Dispatch154.3550FMNWPTF688
Box Elder County FireFire/EMS/Sheriff West (Dunn Peak)154.8000
In 156.0150
FMNWGR640
Box Elder County FireFire/EMS Paging156.0150FMNKVI666

Utah Communications Authority (P25)

Project 25 · System ID 00A

Utah Communications Authority (P25) talkgroups
AgencyDescriptionTalkgroupHexMode
Box Elder County FireBox Elder County Fire – Dispatch47281278T
Box Elder County FireBox Elder County Fire – Dispatch47291279T
Box Elder County FireSheriff Encrypted47271277T
Box Elder County FireBox Elder County Fire – Alternate4730127aT
Box Elder County FireBox Elder County Fire – Alternate4731127bT
Box Elder County FireBox Elder County Fire – Alternate4732127cT
Box Elder County FireCar to Car47561294T
Box Elder County FireCar to Car4766129eT

Nearest trunked radio sites

Distances are measured from the center of Riverside.

Newton Hill · Utah Communications Authority (P25)
Project 25 · RFSS 9 · Site 9 (hex 9) · NAC 06D · about 11 mi away
Control 769.09375, 774.71875
Voice 770.96875, 771.41875, 771.55625, 771.86875, 772.03125, 772.05625, 772.78125, 773.06875, 773.94375, 774.69375
Cache County Simulcast · Utah Communications Authority (P25)
Project 25 · RFSS 16 · Site 16 (hex 10) · NAC 3F8 · about 18 mi away
Control 770.05625, 774.59375
Voice 771.20625, 771.68125, 772.20625, 772.55625, 773.19375, 773.74375, 773.79375, 773.93125, 774.20625
Howell · Utah Communications Authority (P25)
Project 25 · RFSS 55 · Site 55 (hex 37) · NAC 807 · about 21 mi away
Control 770.34375, 774.89375
Voice 770.91875, 771.58125, 771.79375, 772.49375, 773.64375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Riverside?

We do not have a fire dispatch channel listed specifically for Riverside. The county-level fire dispatch channels in the same county: Box Elder County Fire 154.3550 MHz, narrow FM, no tone.

Do fire departments and EMS use a trunked radio system in Riverside?

Yes. The county-level systems that cover Riverside are Fire and EMS talkgroups are listed for Utah Communications Authority (P25) (Project 25): 8 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Riverside?

The analog conventional channels can be heard on any scanner; a trunking scanner that supports Project 25 is needed for the trunked talkgroups.

What are the control channels for trunked radio in Riverside?

For Riverside, start with the Newton Hill site of Utah Communications Authority (P25). Its control channels are 769.09375, 774.71875 MHz. Program a control channel first; the scanner finds the voice channels from it.