About Sonora Fire and EMS Frequencies
Quick answer: County-level ems dispatch that covers Sonora: Sutton County EMS 151.4525 MHz, narrow FM, 97.4 PL.
- 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
Data updated .
Sutton County channels that also cover Sonora
EMS Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Sutton County EMS | Sutton County EMS – Dispatch | 151.4525 In 155.0625 | 97.4 PL | FMN | WQQI736 |
Nearest trunked radio sites
Distances are measured from the center of Sonora.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does EMS or the ambulance service use in Sonora?
We do not have a EMS dispatch channel listed specifically for Sonora. The county-level EMS dispatch channels in the same county: Sutton County EMS 151.4525 MHz, narrow FM, 97.4 PL.
What scanner do I need to listen to fire and EMS in Sonora?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in Sonora?
For Sonora, start with the Loma Alta site of Greater Austin/Travis Regional Radio System (GATRRS). Its control channels are 153.8225, 154.0325 MHz. Program a control channel first; the scanner finds the voice channels from it.