Skip to content

Gardendale Fire and EMS Frequencies

We do not have frequencies listed specifically for Gardendale in Ector County, Texas yet. Countywide channels for Ector County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Gardendale 800 MHz (Greater Austin/Travis Regional Radio System (GATRRS)), about 7 miles away.

About Gardendale Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Gardendale: Ector County Fire 154.1450 MHz, narrow FM, 88.5 PL. Trunked: Permian Basin Interoperable Radio Communications System, for example Ector County Fire talkgroup 405 (hex 195).

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Permian Basin Interoperable Radio Communications System: 4 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Gardendale, start with the Gardendale 800 MHz site of Greater Austin/Travis Regional Radio System (GATRRS), about 7 miles away. Its control channels: 856.2375, 856.7375 MHz.
  • 1 listed entry is marked encrypted. No scanner can decode encrypted audio.

Data updated .

Ector County channels that also cover Gardendale

Fire Dispatch

Fire Dispatch frequencies for Ector County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Ector County FireVolunteer Fire Dispatch154.1450
In 150.7900
88.5 PLFMNWNBN876
Ector County FireVolunteer Fire Paging154.400071.9 PLFMNWNBN876

Permian Basin Interoperable Radio Communications System

Permian Basin Interoperable Radio Communications System talkgroups
AgencyDescriptionTalkgroupHexMode
Ector County FireEctor County Fire – Dispatch (patch)405195D
Ector County FireEctor County Fire – Fire Ground407197D
Midland International Air and Space Port FireFire/EMS Training44124ac5cT
1 encrypted talkgroup (cannot be monitored)
Permian Basin Interoperable Radio Communications System encrypted talkgroups
AgencyDescriptionTalkgroupHexMode
Midland International Air and Space Port FireAirport Fire Tactical44107ac4bT Encrypted

Nearest trunked radio sites

Distances are measured from the center of Gardendale.

Gardendale 800 MHz · Greater Austin/Travis Regional Radio System (GATRRS)
RFSS 1 · Site 88 (hex 58) · NAC 130 · about 7 mi away
Control 856.2375, 856.7375
Voice 855.2125, 858.7375, 859.2375, 859.7375
Odessa · Greater Austin/Travis Regional Radio System (GATRRS)
RFSS 1 · Site 92 (hex 5C) · NAC 130 · about 12 mi away
Control 774.06875, 774.53125
Voice 773.03125, 773.31875, 773.78125
Odessa · Permian Basin Interoperable Radio Communications System
RFSS 1 · Site 1 (hex 1) · about 13 mi away
Control 858.4875, 858.9875, 859.4875, 859.9875
Voice 854.9625, 855.4875, 855.9875, 856.4875, 856.9375, 857.2125, 857.4875, 857.9875
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Gardendale?

We do not have a fire dispatch channel listed specifically for Gardendale. The county-level fire dispatch channels in the same county: Ector County Fire 154.1450 MHz, narrow FM, 88.5 PL.

Do fire departments and EMS use a trunked radio system in Gardendale?

Yes. The county-level systems that cover Gardendale are Fire and EMS talkgroups are listed for Permian Basin Interoperable Radio Communications System: 4 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Gardendale?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Gardendale?

For Gardendale, start with the Gardendale 800 MHz site of Greater Austin/Travis Regional Radio System (GATRRS). Its control channels are 856.2375, 856.7375 MHz. Program a control channel first; the scanner finds the voice channels from it.