Skip to content

Leming Fire and EMS Frequencies

We do not have frequencies listed specifically for Leming in Atascosa County, Texas yet. Countywide channels for Atascosa County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Southeast Simulcast (Alamo Area Regional Radio System (AARRS)), about 17 miles away.

About Leming Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Leming: Atascosa County Fire 153.9500 MHz, narrow FM, 203.5 PL. County-level ems dispatch that covers Leming: Atascosa County EMS 155.7300 MHz, narrow FM, 203.5 PL.

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • 2 conventional channels use a digital mode (P25), which needs a scanner that decodes that mode.

Data updated .

Atascosa County channels that also cover Leming

Fire Dispatch

Fire Dispatch frequencies for Atascosa County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Atascosa County FireAtascosa County Fire – Dispatch153.9500
In 159.0000
203.5 PLFMNWNCR650

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Atascosa County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Atascosa County FireFire D (Poteet)151.3175
In 153.8975
NAC 293P25WNCR650
Atascosa County FireFire D (Jourdanton)158.7975
In 156.1575
NAC 293P25WNCR650

EMS Dispatch

EMS Dispatch frequencies for Atascosa County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Atascosa County EMSAtascosa County EMS – Dispatch155.7300
In 154.7700
203.5 PLFMNKVF676

Nearest trunked radio sites

Distances are measured from the center of Leming.

Southeast Simulcast · Alamo Area Regional Radio System (AARRS)
RFSS 170 · Site 170 (hex AA) · NAC 0B4 · about 17 mi away
Control 852.275, 852.7875, 852.8375, 853.1875, 853.5125, 853.8375, 853.8875, 854.9125, 855.6125, 855.9375, 858.2875, 858.7625
South Bexar · Greater Austin/Travis Regional Radio System (GATRRS)
RFSS 2 · Site 54 (hex 36) · about 18 mi away
Control 774.31875, 774.78125
Voice 770.94375, 773.28125, 773.56875, 774.03125
Harlandale (South San Antonio) · Greater Austin/Travis Regional Radio System (GATRRS)
RFSS 2 · Site 35 (hex 23) · NAC 130 · about 19 mi away
Control 769.76875, 770.29375
Voice 771.09375, 772.36875, 773.14375, 774.91875
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Leming?

We do not have a fire dispatch channel listed specifically for Leming. The county-level fire dispatch channels in the same county: Atascosa County Fire 153.9500 MHz, narrow FM, 203.5 PL.

What frequency does EMS or the ambulance service use in Leming?

We do not have a EMS dispatch channel listed specifically for Leming. The county-level EMS dispatch channels in the same county: Atascosa County EMS 155.7300 MHz, narrow FM, 203.5 PL.

What scanner do I need to listen to fire and EMS in Leming?

The analog conventional channels can be heard on any scanner; a scanner that decodes P25 is needed for the digital conventional channels.

What are the control channels for trunked radio in Leming?

For Leming, start with the Southeast Simulcast site of Alamo Area Regional Radio System (AARRS). Its control channels are 852.275, 852.7875, 852.8375, 853.1875 MHz. Program a control channel first; the scanner finds the voice channels from it.