About Fargo Fire and EMS Frequencies
Quick answer: County-level fire dispatch that covers Fargo: Ellis County Fire 159.1800 MHz, narrow FM, 173.8 PL.
- 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
Data updated .
Ellis County channels that also cover Fargo
Fire Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Ellis County Fire | Ellis County Fire – Dispatch | 159.1800 In 153.9350 | 173.8 PL | FMN | WPNW712 |
Nearest trunked radio sites
Distances are measured from the center of Fargo.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does the fire department use in Fargo?
We do not have a fire dispatch channel listed specifically for Fargo. The county-level fire dispatch channels in the same county: Ellis County Fire 159.1800 MHz, narrow FM, 173.8 PL.
What scanner do I need to listen to fire and EMS in Fargo?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in Fargo?
For Fargo, start with the Elk City site of Oklahoma Wireless Interoperability Network (OKWIN) (P25). Its control channels are 856.2125, 857.2125 MHz. Program a control channel first; the scanner finds the voice channels from it.