About Rulo Fire and EMS Frequencies
Quick answer: County-level fire dispatch that covers Rulo: Richardson County Fire 155.6775 MHz, narrow FM, 031 DPL.
- 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
Data updated .
Richardson County channels that also cover Rulo
Fire Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Richardson County Fire | East | 155.6775 In 159.0075 | 031 DPL | FMN | — |
| Richardson County Fire | West | 156.2325 | 031 DPL | FMN | — |
Nearest trunked radio sites
Distances are measured from the center of Rulo.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does the fire department use in Rulo?
We do not have a fire dispatch channel listed specifically for Rulo. The county-level fire dispatch channels in the same county: Richardson County Fire 155.6775 MHz, narrow FM, 031 DPL.
What scanner do I need to listen to fire and EMS in Rulo?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in Rulo?
For Rulo, start with the Barada site of Omaha Regional Interoperability Network (ORION). Its control channels are 855.9625, 856.4375 MHz. Program a control channel first; the scanner finds the voice channels from it.