About Table Rock Fire and EMS Frequencies
Quick answer: County-level fire dispatch that covers Table Rock: Pawnee, County of 154.3925 MHz, FM, 186.2 PL.
- 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
Data updated .
Pawnee County channels that also cover Table Rock
Fire Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Pawnee, County of | Fire/EMS Dispatch | 154.3925 | 186.2 PL | FM | WQAL998 |
Nearest trunked radio sites
Distances are measured from the center of Table Rock.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does the fire department use in Table Rock?
We do not have a fire dispatch channel listed specifically for Table Rock. The county-level fire dispatch channels in the same county: Pawnee, County of 154.3925 MHz, FM, 186.2 PL.
What scanner do I need to listen to fire and EMS in Table Rock?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in Table Rock?
For Table Rock, start with the Steinauer site of Omaha Regional Interoperability Network (ORION). Its control channels are 857.9375, 858.4875 MHz. Program a control channel first; the scanner finds the voice channels from it.