About Gray Fire and EMS Frequencies
Quick answer: County-level fire dispatch that covers Gray: Jones County Fire 159.4500 MHz, NXDN48, RAN 45.
- 1 conventional channel uses a digital mode (NXDN48), which needs a scanner that decodes that mode.
Data updated .
Jones County channels that also cover Gray
Fire Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Jones County Fire | Jones County Fire – Dispatch | 159.4500 In 153.8450 | RAN 45 | NXDN48 | WQEL267 |
Nearest trunked radio sites
Distances are measured from the center of Gray.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does the fire department use in Gray?
We do not have a fire dispatch channel listed specifically for Gray. The county-level fire dispatch channels in the same county: Jones County Fire 159.4500 MHz, NXDN48, RAN 45.
What scanner do I need to listen to fire and EMS in Gray?
A scanner that decodes NXDN48 is needed for the digital conventional channels.
What are the control channels for trunked radio in Gray?
For Gray, start with the Bibb County Simulcast site of Central Georgia Interoperable Regional Radio System (CGIRRS). Its control channels are 854.0625, 854.7125, 855.2375, 855.4875 MHz. Program a control channel first; the scanner finds the voice channels from it.