Skip to content

Basalt Fire and EMS Frequencies

Basalt in Pitkin County, Colorado has 1 conventional frequency and 0 trunked talkgroups listed for local fire and EMS agencies. The closest trunked radio site we have is Crown Mountain (State of Colorado DTRS), about 3 miles away.

Basalt also extends into Eagle County.

About Basalt Fire and EMS Frequencies

Quick answer: Fire dispatch for Basalt: Basalt Fire 154.4450 MHz, narrow FM, 100.0 PL. Trunked: State of Colorado DTRS, for example Pitkin County Fire talkgroup 11621 (hex 2d65).

  • 7 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: State of Colorado DTRS: 4 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Basalt, start with the Crown Mountain site of State of Colorado DTRS, about 3 miles away. Its control channels: 852.95, 853.1625, 853.45 MHz.

Data updated .

Basalt conventional frequencies

Fire Dispatch

Fire Dispatch frequencies for Basalt
AgencyDescriptionFrequency (MHz)ToneModeFCC
Basalt FireBasalt Fire Department154.4450
In 153.7700
100.0 PLFMNKXX453

Pitkin County channels that also cover Basalt

Fire Dispatch

Fire Dispatch frequencies for Pitkin County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pitkin County FirePitkin County Fire – Dispatch151.0700
In 159.4650
173.8 PLFM—
Pitkin County FirePitkin County Fire – Dispatch155.7825
In 159.4650
173.8 PLFMN—
Snowmass FireSnowmass Fire – Dispatch154.3850
In 153.8900
162.2 PLFMNKYT252

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Pitkin County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pitkin County FirePitkin County Fire – Elephant153.9500FMWNSE825
Pitkin County FirePitkin County Fire – Marble154.0000186.2 PLFMWNSE825
Pitkin County FirePitkin County Fire – Tactical Channel / Training154.3250FMWNSE825

State of Colorado DTRS

State of Colorado DTRS talkgroups
AgencyDescriptionTalkgroupHexMode
Pitkin County FireCounty Fire116212d65D
Pitkin County FirePitkin County Fire – Tactical Channel116162d60D
Pitkin County FirePitkin County Fire – Tactical Channel116172d61D
Pitkin County FireAspen Mountain Rescue (Tactical 5)116182d62D

Nearest trunked radio sites

Distances are measured from the center of Basalt.

Crown Mountain · State of Colorado DTRS
RFSS 2 · Site 86 (hex 56) · NAC D16 · about 3 mi away
Control 852.95, 853.1625, 853.45, 853.975
Voice 852.45
Williams Hill · State of Colorado DTRS
RFSS 2 · Site 68 (hex 44) · NAC D14 · about 7 mi away
Control 852.3375, 852.5875, 852.7375, 853.2875
Voice 851.1375, 851.325, 851.6, 851.8375
Red Table Mountain · State of Colorado DTRS
RFSS 2 · Site 53 (hex 35) · NAC D15 · about 9 mi away
Control 857.1375, 857.6375, 858.1375, 858.6375
Voice 856.1375, 856.6375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Basalt?

Fire dispatch channels listed for Basalt: Basalt Fire 154.4450 MHz, narrow FM, 100.0 PL.

Do fire departments and EMS use a trunked radio system in Basalt?

Yes. The county-level systems that cover Basalt are Fire and EMS talkgroups are listed for State of Colorado DTRS: 4 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Basalt?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Basalt?

For Basalt, start with the Crown Mountain site of State of Colorado DTRS. Its control channels are 852.95, 853.1625, 853.45, 853.975 MHz. Program a control channel first; the scanner finds the voice channels from it.

Are Basalt fire and EMS frequencies encrypted?

None of the 1 conventional frequencies listed for Basalt are marked encrypted.